Couple small changes here and there that I figured I'd share, though it's nothing major.
I'm working on a custom front tube bumper, just have to decide what route I want to go. I know the basic design I want, but have to figure out if I want to go full custom build (with the help [and tools] of a friend) or buy one for a 'Yota and make it fit.
In the meantime, I blacked out my front burger with Rustoleum bedliner:
I did the "hood rod mod":
My coworker/friend helped me out and replace my lower radiator support after this happened to the OEM one:
My CB install is done, up and running nicely:
I made some bacon:
Replaced my PCV valve and diagnosed a possible head gasket failure as a combination of old coolant, moisture in the crank case from not driving the truck normally for a week and a half...changed the oil and did a flush and fill with Zerex Asian Vehicle 50/50. Been good ever since
I organized my mortar tins a little bit better:
And machined my own custom battery tie down with kickass iron cross wingnuts:
"This piece adds 25 HP and looks bitchin' too!"
