North East Xterra Club https://www.nexterra.org/forums/ |
|
(2nd Gen) Tips on removing tow hook - front bolt stuck https://www.nexterra.org/forums/viewtopic.php?f=51&t=9014 |
Page 1 of 1 |
Author: | eausport [ Fri Jul 22, 2016 2:15 pm ] |
Post subject: | (2nd Gen) Tips on removing tow hook - front bolt stuck |
Was in the process of installing my Hefty Radiator Skid before ECXC when I realized my front tow hook bolt was seized into the weld nut inside the frame. I didn't want to force and break it so I let it be. There's no clear path to spray down the inside bolt w/ PB Blaster due to it being inside the box frame. However, there is a very small side opening in the frame a few inches above the bolt and so I inserted a small hose and began spraying that w/ PB Blaster hoping it would drip down to the seized weld nut and hopefully help loosen the bolt (wishful thinking) No luck yet but will try this for a week but if nothing positive comes from this - anyone have other ideas? Thanks in advance! |
Author: | c3PO [ Fri Jul 22, 2016 5:53 pm ] |
Post subject: | Re: (2nd Gen) Tips on removing tow hook - front bolt stuck |
50/50 Acetone and Automatic transmission fluid. Or Map Gas. http://www.jalopyjournal.com/forum/thre ... wn.350800/ |
Author: | theplasticone [ Fri Jul 22, 2016 9:21 pm ] |
Post subject: | Re: (2nd Gen) Tips on removing tow hook - front bolt stuck |
Well, when I tried to pull mine to install my Hardcore bumper, the weld nut snapped immediately - didn't even get a half turn out of it. Four hours of Sawzalling through the entire hook itself as well as the bolt, and a little bit of oxy-ace cutting, ensued. Fortunately the rear one came out without too much of a fight. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |