Bklyn.X wrote:
I don't know how you are equipped or your level of expertise so please do not take offence when I say keep in mind that even though Shrock?s and Skidrow?s plates are made with 3/16" thick steel they not just a flat piece of steel. They are bent up on the sides to give them a bit more strength, not an easy task without the proper equipment.
Just a heads up bro?
fully agree.... there is a lot of little pieces welded on there + some bends + drilling some holes....
If you are really going to use it, I'll take the mesurements for you before I put it on the truck, while it's still intact. but for $200.... not too sure I'd go through all that trouble!