North East Xterra Club
https://www.nexterra.org/forums/

Teardown complete. What now?
https://www.nexterra.org/forums/viewtopic.php?f=51&t=3734
Page 1 of 1

Author:  spalind [ Wed Jun 10, 2009 7:13 am ]
Post subject:  Teardown complete. What now?

OK, last night I finished the teardown of the X as far as I need to go. UCAs, CVs, front diff, front crossmember, front and rear driveshafts, drums, brakes , rear axles and rear diff are all out of the X and on the floor.

Now I want to know what small parts (nuts, bolts, seals, etc.) would people recommend replacing now that all of this stuff is out. Yes, the rear axles are all the way out so I guess I should replace those seals as well.

Parts that I KNOW I need to replace but don't know the part #'s for would be the rear brake connectors that are threaded and go from the hydraulic line and into the back of the brake assembly (they were really rusty and stripped a bit during their removal), the cotter pin and tube it passes through connecting the parking brake line to the back of the brake assembly, a couple of the nuts that attach the third member to the rear axle housing, the rear axle seals that supposedly need to be replaced when you remove an axle and the seal/gasket that goes between the third member and the rear axle housing. If anyone knows any of these part #'s it would be greatly appreciated.

Author:  XVTer [ Wed Jun 10, 2009 7:34 am ]
Post subject: 

Check out THIS SITE

It may help you out a little, but I can't seem to find the actual part numbers. Unfortunately, there's only illustrations for a few trucks prior to '05.

Good luck.

Author:  Bklyn.X [ Wed Jun 10, 2009 9:31 am ]
Post subject: 

Try HERE, HERE and HERE for part #?s.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/