| North East Xterra Club https://www.nexterra.org/forums/ |
|
| Cv goes boom https://www.nexterra.org/forums/viewtopic.php?f=40&t=9165 |
Page 1 of 1 |
| Author: | TKX [ Sat Dec 10, 2016 7:14 pm ] |
| Post subject: | Cv goes boom |
Finally had time to work on the truck, got one side fixed... The housing on the hub side blew up and damaged my radflo too  These were the Nissan value advantage cvs, not much of a value.... Other side snapped up by the diff... That's a tomorrow project.... Replaced upper ball joints too while I had it apart....   Sent from my SM-G920V using Tapatalk |
|
| Author: | DirtySocks [ Sat Dec 10, 2016 8:12 pm ] |
| Post subject: | Cv goes boom |
Hope you have a warm garage to work in Tony. And hoping the fix goes well tomorrow. Sent from my iPhone using Tapatalk |
|
| Author: | Bass4Runner [ Sat Dec 10, 2016 8:15 pm ] |
| Post subject: | Re: Cv goes boom |
Ouch !! |
|
| Author: | TKX [ Sat Dec 10, 2016 8:22 pm ] |
| Post subject: | Re: Cv goes boom |
Thanks... Actually I did.. Warmed my garage all day.... I've never seen one fail like this... Oh well... Sent from my SM-G920V using Tapatalk |
|
| Author: | Scott Farris [ Sat Dec 10, 2016 9:15 pm ] |
| Post subject: | Re: Cv goes boom |
Tony, I'm sure I too late but I do have my two failed shafts that both broke at the diff spline. They are available for parts if you have to rebuild another. Both shafts are OEM with less than 40K miles. On another note, my RCV diff side shaft arrived today! Now i just have to press a bearing on and install it. I have seals / snap rings, and the bearing. Best! Scott |
|
| Author: | LizardKing [ Tue Dec 13, 2016 8:09 am ] |
| Post subject: | Re: Cv goes boom |
Ouch. Where did it fail (street, trail, etc)? |
|
| Author: | TKX [ Tue Dec 13, 2016 8:46 am ] |
| Post subject: | Re: Cv goes boom |
Trail... Got hung up on some rocks not a very hard section either .. Passenger side blew apart first then driver side. Driver side broke in the joint by diff, both shafts were fine surprisingly. Sent from my SM-G920V using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|