Just wanted to give everyone on here a heads up that the clutch pedal can be adjusted fairly easily. ToddG on ClubFrontier did a write-up a while back on how to do it. All that is required is a 12 and 14mm wrenches. Long story short, there is a clevis that is attached to the clutch pedal linkage. You remove the clevis pin, loosen the jam nut on the back of the clevis, spin the clevis inwards on the threaded rod (1/2-2 full turns depending on how you like it), reinsert the clevis pin, and finally tighten the jam nut. Then take the 14mm wrench, loosen the jam nut on the cruise control switch, thread the switch inwards (easiest if the wire is disconnected first) until the switch is depressed with the clutch all the way out. Tighten the jam nut and you're done!

I've done this on both the Frontier and my new X and it makes driving the truck about 10x easier. No more huge clutch pedal throw.

http://www.clubfrontier.org/forums/f23/ ... eed-50112/