murphy wrote:
You only need to melt mod the lower portion. The window washer motor is behind the upper portion you indicated. It would probably be better if you left that area just like it is. I ran without fender liners for a few weeks. I was trying to decide if I was going to use sheet metal or something similar, or reuse the factory liners. The washer motor is pretty close behind that bump.
Awesome will do! Thanks I did got that upper area a little going out to check to make sure I didn't damage anything , didn't realize what was behind it .
I'm good hardly touched it , glad a i didn't push that in .
Well I got both sides done and I think I should be good , we'll see when I get them on .
Thanks again !
Sent from my iPhone using Tapatalk