Besides maintenance I gots a long list, some of it has been waiting for years to get to and doubt I’ll get to it all;
Install front anti sway (already have parts)
Re-locate e-brake cable rocker (drill and tap above frame rail)
Weld tabs (already have parts) to radius arm and axle for ARB and brake lines
Box out radius arm mounts on crossmember
California Cat delete (already have parts)
New cover for front driveshaft that California Cat melted off
Figure out and make new oil pan skid
High Steer (already have Reid knuckles and hardware)
Relocate Track Bar mount after High Steer ((already have parts)
SOA (already have parts)
Slip Yoke Eliminator (already have part)
New rear axle (will need to order after SOA and SYE installed)
Might need antiwrap kit after SOA
USB charger in dash and back near rear outlet
Small led light over cup holder
Roof lights (already have parts)
Rock lights (already have parts)
Holy crap am I behind.
I can get into more detail on any of this crap if you’d like but I think that’s the list…so far…