It is currently Thu Feb 27, 2020 10:07 pm

Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: RockyMtnX rear recovery points install! (pictures)
PostPosted: Wed May 28, 2014 7:13 pm 

Joined: Tue Nov 19, 2013 8:33 pm
Posts: 73
Location: Weehawken, New Jersey
So, last Friday I finally got around to installing my RockyMtnX rear recovery points. It was super easy to do with minimal tools.
-rubber mallet, 1/2 driver, 17-19mm sockets, dremel, power inverter
-Remove factory tow hitch
-remove bumper
-measure again
-have a friend (or jack stand) hold the rear bumper up
-bolt in!
-pull out stuck Sierras, XJs, and FJs!

-tow hitch and bumper, GONE!

-800W inverter plus dremel to cut the bumper

-measure twice, cut once!

-after a day of wheeling down in south jersey

-just pulled out a sierra from some muddy gravel. I'm not stuck, just threw her in reverse and got right out!

The recovery points worked beautifully! they did not budge a nanometer after a few pulls through out the day, looks clean and flush too! A lot of people thought i bought a new bumper. The best part, no more lost ground clearance/angle of departure! If you can't afford a rear bumper yet, these RockyMtnX recovery points are worth the money and cutting up your bumper!

bonus, on top of a nice hill climb

2010 Xterra Offroad
-Factory: Skids, Rear Locking Diff
-Shrockworks Gas Tank Skid
-Shrockworks Rock Sliders
-Bfgoodrich TA KOs 33"
-Rocky Mtn Rear Recovery Points

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Theme designed by & programy © 2008
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
[ Time : 0.322s | 13 Queries | GZIP : Off ]
All times are UTC - 5 hours