North East Xterra Club http://www.nexterra.org/forums/ |
|
Rear diff breather slack http://www.nexterra.org/forums/viewtopic.php?f=22&t=9364 |
Page 1 of 1 |
Author: | Bear [ Sun Jul 30, 2017 10:50 am ] |
Post subject: | Rear diff breather slack |
Hello everyone quick question. Doing my rear diff breather extension to tail light today and just finished up. Do you think about 8 inch coil is enough slack for the axle flex? See pic Thanks in advance Mike Sent from my iPhone using Tapatalk |
Author: | theplasticone [ Sun Jul 30, 2017 12:59 pm ] |
Post subject: | Re: Rear diff breather slack |
Should be fine. Jack up by the frame (both sides, then just the left side) and let the axle hang, you'll know that way. I think I bought four or five feet of line when I did mine and all of it is coiled up in there, so I have way more than I need (plus, if water ever gets in through the filter, it'll end up sitting in the several coils rather than going straight to the breather plug...and I have room to grow if I lift higher). |
Author: | Bear [ Mon Jul 31, 2017 7:33 am ] |
Post subject: | Re: Rear diff breather slack |
theplasticone wrote: Should be fine. Jack up by the frame (both sides, then just the left side) and let the axle hang, you'll know that way. I think I bought four or five feet of line when I did mine and all of it is coiled up in there, so I have way more than I need (plus, if water ever gets in through the filter, it'll end up sitting in the several coils rather than going straight to the breather plug...and I have room to grow if I lift higher). Thanks bud! I'll do that and see if there is enough slack , I think I should be good, was happy the barb came out without issue thought it was going to be tough but pretty straight forward. Sent from my iPhone using Tapatalk |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |